Automobile industry in Pakistan

The Automobile industry has been an active and growing field in Pakistan for a long time, however not as much established to figure in the prominent list of the top automotive industries. Pakistan has a large range of motorbikes which are used throughout the whole of the country for terms of transportation. In the past, there have been talks about expanding the industry however nothing has been heard till now. Cars are imported to the country in large figures from Japan and people buy mostly manual cars rather than automatic.

Steam

Steam power, usually using an oil- or gas-heated boiler, was also in use until the 1930s but had the major disadvantage of being unable to power the car until boiler pressure was available (although the newer models could achieve this in well under a minute). It has the advantage of being able to produce very low emissions as the combustion process can be carefully controlled. Its disadvantages include poor heat efficiency and extensive requirements for electric auxiliaries

Electric

The first electric cars were built around 1832, well before internal combustion powered cars appeared. For a period of time electrics were considered superior due to the silent nature of electric motors compared to the very loud noise of the gasoline engine. This advantage was removed with Hiram Percy Maxim's invention of themuffler in 1897. Thereafter internal combustion powered cars had two critical advantages: 1) long range and 2) high specific energy (far lower weight of petrol fuel versus weight of batteries). The building of battery electric vehicles that could rival internal combustion models had to wait for the introduction of modern semiconductorcontrols and improved batteries. Because they can deliver a high torque at low revolutions electric cars do not require such a complex drive train and transmission as internal combustion powered cars. Some post-2000 electric car designs such as the Venturi Fétish are able to accelerate from 0-60 mph (96 km/h) in 4.0 seconds with a top speed around 130 mph (210 km/h). Others have a range of 250 miles (400 km) on the United States Environmental Protection Agency (EPA) highway cycle requiring 3-1/2 hours to completely charge

Biofuels

Ethanol, other alcohol fuels (biobutanol) and biogasoline have widespread use an automotive fuel. Most alcohols have less energy per liter than gasoline and are usually blended with gasoline. Alcohols are used for a variety of reasons - to increase octane, to improve emissions, and as an alternative to petroleum based fuel, since they can be made from agricultural crops. Brazil's ethanol program provides about 20% of the nation's automotive fuel needs, as a result of the mandatory use of E25 blend of gasoline throughout the country, 3 million cars that operate on pure ethanol, and 6 million dual or flexible-fuel vehicles sold since 2003.that run on any mix of ethanol and gasoline. The commercial success of "flex" vehicles, as they are popularly known, have allowed sugarcane based ethanol fuel to achieve a 50% market share of the gasoline market by April 2008.

Gasoline

Gasoline engines have the advantage over diesel in being lighter and able to work at higher rotational speeds and they are the usual choice for fitting in high-performance sports cars. Continuous development of gasoline engines for over a hundred years has produced improvements in efficiency and reduced pollution. Thecarburetor was used on nearly all road car engines until the 1980s but it was long realised better control of the fuel/air mixture could be achieved with fuel injection. Indirect fuel injection was first used in aircraft engines from 1909, in racing car engines from the 1930s, and road cars from the late 1950s.Gasoline Direct Injection (GDI) is now starting to appear in production vehicles such as the 2007 (Mark II) BMW Mini. Exhaust gases are also cleaned up by fitting a catalytic converter into the exhaust system. Clean air legislation in many of the car industries most important markets has made both catalysts and fuel injection virtually universal fittings. Most modern gasoline engines also are capable of running with up to 15% ethanol mixed into the gasoline - older vehicles may have seals and hoses that can be harmed by ethanol. With a small amount of redesign, gasoline-powered vehicles can run on ethanol concentrations as high as 85%. 100% ethanol is used in some parts of the world (such as Brazil), but vehicles must be started on pure gasoline and switched over to ethanol once the engine is running. Most gasoline engined cars can also run on LPG with the addition of an LPG tank for fuel storage and carburettor modifications to add an LPG mixer. LPG produces fewer toxic emissions and is a popular fuel for fork-lift trucks that have to operate inside buildings.

Diesel

Diesel-engined cars have long been popular in Europe with the first models being introduced as early as 1922 by Peugeot and the first production car, Mercedes-Benz 260 D in 1936 by Mercedes-Benz. The main benefit of diesel engines is a 50% fuel burn efficiency compared with 27% in the best gasoline engines. A down-side of the Diesel engine is that better filters are required to reduce the presence in the exhaust gases of fine soot particulates called diesel particulate matter. Manufacturers are now starting to fit[when?] diesel particulate filtersto remove the soot. Many diesel-powered cars can run with little or no modifications on 100% biodiesel and combinations of other organic oils.

Production

The large-scale, production-line manufacturing of affordable automobiles was debuted by Ransom Olds at hisOldsmobile factory in 1902. This concept was greatly expanded by Henry Ford, beginning in 1914.As a result, Ford's cars came off the line in fifteen minute intervals, much faster than previous methods, increasing productivity eight fold (requiring 12.5 man-hours before, 1 hour 33 minutes after), while using less manpower.It was so successful, paint became a bottleneck. Only Japan black would dry fast enough, forcing the company to drop the variety of colors available before 1914, until fast-drying Duco lacquer was developed in 1926. This is the source of Ford's apocryphal remark, "any color as long as it's black".In 1914, an assembly line worker could buy a Model T with four months' pay